INSTALLATION INSTRUCTIONS - BYPASS CIRCUIT INSTALL
For ease of service, it is highly recommended to install a bypass circuit around the regenerative dryer. Follow the diagram below when installing a bypass circuit. Verify that system pressure is relieved prior to performing installation. Air Supply
A. Inlet Ball Valve B. Bypass Ball Valve C. Outlet Ball Valve
Using the dryer: Open the inlet and outlet ball valves and close the bypass valve to direct air flow through the regenerative dryer. This will provide clean, dry air downstream.
Bypassing the dryer: Close the inlet and outlet ball valves and open the bypass valve to direct airflow around the dryer. This will allow service or maintenance to be preformed without shutting down total compressed air supply
INSTALLATION INSTRUCTIONS - DRYER INSTALLTION
IMPORTANT: Tsunami Regenerative Dryers are configurable in multiple variations. Before beginning installation it is important to determine the direction of air flow which best meets your installation application requirements. All dryers contained in this manual follow the same installation procedures.
Remove all system pressure. Using the appropriate hardware (not included), mount dryer bracket to wall. Once the wall bracket has been properly secured to the wall, place the dryer mounting rail into the slot(s) of the wall bracket. Install the supplied FEMALE JIC fitting to outlet port of the Tsunami prefilter assembly. Use appropriate thread sealant. Determine preferred direction of flow. IMPORTANT: Air must travel through the Tsunami filters prior to entering the regenerative dryer. Using the appropriate thread sealant, install the MALE JIC connector to either the left or right INLET / AUX port of the dryer. L to R Flow.
Using an adjustable or 5/8” wrench, plug the remaining open ports with the provided 1” port plugs and large hex tool. Use appropriate thread sealant. Attach the filter assembly to the dryer housing by connecting the MALE and FEMALE JIC fittings. Tighten firmly.
Attach 3/8” clear plastic tubing to the bottom of the Float Drains or Moisture Minder® Filter Drains. Follow all local and state regulations when routing the drain lines. For 110v dryers, plug unit into wall. For 220v dryers, install a 220/230/240 single phase plug on flying leads and plug into appropriate outlet or hardwire into gauge box. Make sure all local electrical codes are followed and that work is performed by a qualified representative.
INSTALLATION INSTRUCTIONS - Install Tank
Install tank using universal mounting straps. Wrap straps around front of tank and secure on back side of tank. Using 5/16” cap screws, affix straps to wall bracket. Tighten bands on tank using 1/4x3” cap screws.